Supporting UK Composites

Costs

How much do composites cost compared to other materials?

The costs associated with composite materials can generally be broken down into five areas – fibre (reinforcement), resin (matrix), consumable materials (needed to assist the combination of reinforcement and matrix), labour costs and machine costs.

The major cost is typically the reinforcement element, the fibre for which can be off a spool or pre-woven into a stitched fabric depending on the manufacturing process.

Download a technical sheet on  Life Cycle Cost of FRP Structures

Fibre Cost Trends

There are a number of variants within each material that affect the overall cost. Generally the mechanical properties and environmental resistance, particularly temperature resistance, increase the cost.

Resin Costs

The resin is the key controllable item that can reduce the other costs. Though not the single major cost, the chemistry and processability of the resin is critical. For example, prepregs and wet / dry lay-up materials can be cured at ambient temperature (or little higher), made possible by tailored resin formulations. The resin also affects the costs involved in wet-out of fibre mats, room temperature out-life, frozen storage life and good handling for laminating by hand.

Generally the mechanical properties and environmental resistance, particularly temperature resistance, increase with increasing cost.

Consumable Costs

Consumables vary depending on the chosen material processing and lay-up methods. They do not form a major part of the overall costs and cost trends would need to be identified for specific applications.

Labour and Machine Costs

These are intertwined and are dependent on chosen processing technique(s). Specialist motor racing and aerospace laminators are charged at far higher rates than construction labour gangs, since the construction market cannot tolerate such high labour costs. However, this is overcome by specialist training by material suppliers and the creation of lists of approved installation contractors for tendering purposes.

Overall Costs

It is impossible to give a single comparison of composite costs and traditional material costs (eg. steel) because suppliers use discretion on a job-by-job basis and the prices of raw materials are frequently updated to reflect advances in material processing technology. The range of composite / steel cost ratios usually spans between 5 and 10, but the final delivered product is often no more expensive than, say, steel alternatives. This is due to easier installation of lighter composite components and far lower whole-life maintenance costs. It is recommended that supply chain managers of projects be consulted directly for the initial capital outlay and whole-life cost implications of using composites.

Indirect costs

Additionally, there may be a number of indirect costs, such as quality control, health and safety considerations, etc. which need to be taken into account. Also, there is an increasing emphasis on environmental factors including maintenance, recycling, and disposal, which, over the lifetime of a component, can be important. For many components, the benefits from the use of reinforced polymer composites can become very significant when whole-life costs, rather than just fabrication costs, are included.

APPLY FOR MEMBERSHIP

Exclusive information, support & event offers

Contact

Need more information on composites or membership?